
I sanded the final components of the chair and assembled it.


I sanded the final components of the chair and assembled it.
I am starting to create items for my upcoming online store. One of the items will be these trout silhouettes…
I reused the wheel base for the dust collector, which I no longer needed since I mounted it to the…
My first attempt to carve the Hawaiian Islands Chain was to have it fit all on the bed of the…
I finished an order for some custom national park signs. In between coats of paint and sealer, I did some…
I continued to cut component tiles on the X-Carve. And while the X-Carve works away, I started sanding the piece…
In preparation for our trip to Hawaii next week, I created these custom stoppers out of scraps of thin stock…
The SD card for the QuickDraw Bot went back, and I had to re-flash a new operating system for the…
I purchased from 8MP Camera from LightBurn and added it to the RTL-1390I Laser Cutter. Before installation, I printed a…
I started working on a fly rod rack to sell on Etsy. I am trying to make it so that…
I made a trip to Goby Walnut Products in Portland, probably my favorite source for hardwood, where I discovered some…
Over the last couple of days, I finished the third Simba Simple chair.
As I was getting ready to cut the remaining components tiles for the Simba Simple chair, I realized that I…
With the gluing finished, I started sanding the components and rounded the corners of the legs with the router. I…
You must be logged in to post a comment.