
I started cutting the component tiles for a second Simba Simple chair.



I started cutting the component tiles for a second Simba Simple chair.
I started cutting the second half of the components tiles for the Simba Simple chair. While waiting for the cutting…
I started working on a fly rod rack to sell on Etsy. I am trying to make it so that…
I continued to cut component tiles on the X-Carve. And while the X-Carve works away, I started sanding the piece…
As I was getting ready to cut the remaining components tiles for the Simba Simple chair, I realized that I…
I reused the wheel base for the dust collector, which I no longer needed since I mounted it to the…
I made a trip to Goby Walnut Products in Portland, probably my favorite source for hardwood, where I discovered some…
I finished an order for some custom national park signs. In between coats of paint and sealer, I did some…
Before starting a cutting job, one should make sure that it is the right piece you want to cut. I…
I am having issues with the Anycubic Photon S printer. I ran out of Anycubic green resin and switched over…
I sanded the final components of the chair and assembled it.
The SD card for the QuickDraw Bot went back, and I had to re-flash a new operating system for the…
I finally was able to spend some time at the shop, using the X-Carve to create a battery pack storage…
You must be logged in to post a comment.