![img_0767](https://www.makercave.org/wp-content/uploads/2020/09/img_0767-scaled-thegem-blog-default.jpg)
I am having issues with the Anycubic Photon S printer. I ran out of Anycubic green resin and switched over to the Anycubic gray resin I had purchased a couple of months ago. Now the prints fail. The base and the initial support structure print fine, but nothing of the model (Jill April Angel).
I have relevel the build platform, using both the traditional leveling procedure and the “Flint Reed” method.
I have now resliced the model, using some exposure settings I found on the Internet. Currently waiting the results of the changes…
And the changes seem to have made a difference as the model is now appearing.
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0767.jpg?resize=1024%2C768&ssl=1)
I have also started cutting the components for the Simba Simple Chair on the X-Carve.The original design was for a 4’x4′ sheet of plywood, but the designer was kind enough to break up the layout into 2’x2′ squares. By the end of the day, I will have half of the components needed cut.
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0763.jpg?resize=1024%2C1024&ssl=1)
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0764.jpg?resize=1024%2C1024&ssl=1)
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0766.jpg?resize=1024%2C1024&ssl=1)
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0768.jpg?resize=1024%2C1024&ssl=1)
I also worked on the Expert 24LX vinyl cutter today. I had to reinstall East Cut Studio on MakerCave iMac (lost when the hard drive crashed a couple of months ago). I could not get the license to activate, but luckily I both two licenses for the software. I emailed support, and they responded back that I had to deactivate license from the previous installation first.
And, like that, we entered the dosie dough. I cannot deactivate the license, because the hard drive crashed.Hopefully, they will realize the circularity of the situation and come up with a solution.
I cut a vinyl decal of the Hale Kilolani block cut for my eVScope Pelican case.
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/Hale-Kilolani.jpg?resize=668%2C1024&ssl=1)
![](https://i0.wp.com/www.makercave.org/wp-content/uploads/2020/09/img_0765.jpg?resize=768%2C1024&ssl=1)
You must be logged in to post a comment.