
I finished cutting the final component tiles for the Simba Simple Chair and started assembling.





I finished cutting the final component tiles for the Simba Simple Chair and started assembling.
I finally was able to spend some time at the shop, using the X-Carve to create a battery pack storage…
Before starting a cutting job, one should make sure that it is the right piece you want to cut. I…
Over the last couple of days, I finished the third Simba Simple chair.
I was so happy with the thin stock walnut remnants I picked up at Goby Walnut Products that I picked…
As I was getting ready to cut the remaining components tiles for the Simba Simple chair, I realized that I…
The latest few days I have been working on designing a LEGO minifig display, and here is my first attempt…
I purchased from 8MP Camera from LightBurn and added it to the RTL-1390I Laser Cutter. Before installation, I printed a…
I made a trip to Goby Walnut Products in Portland, probably my favorite source for hardwood, where I discovered some…
Much of making is about trial and error, especially when you are trying new things, and most of the time…
I started working on a fly rod rack to sell on Etsy. I am trying to make it so that…
The SD card for the QuickDraw Bot went back, and I had to re-flash a new operating system for the…
I finished an order for some custom national park signs. In between coats of paint and sealer, I did some…
You must be logged in to post a comment.